Q&A

Q: I have a Chevy Nova with a GM 350 crate engine. The engine has Trick Flow 23° cylinder heads, a Lunati cam, Edelbrock Performer intake, an Edelbrock Performer 600 […]

Can I put a blower on my balanced and blueprinted 383 c.i.d. stocker motor that has 10:1 compression? I just want it for looks, not to race. – G.H. … […]

Q: I own a classic 1970 Mopar with a 440 engine. The engine is bored .040 inch over, has a forged crank, flat top pistons, and ‘452’ cast heads—the original […]

Q: Back in the day, my buddies and I used to rule the local dragstrips. The memories! Today, I’ve got gray hair and I’m mostly stuck in a wheelchair, but […]

Q: I’m building a Ford 302 engine, and I’m looking at camshafts. I’m curious—why did Ford change the firing order on the 5.0L (302) HO engine? A: This question gets […]

I have a question about the optimum distributor rotor tip and terminal gap. Modern replacement parts for our classics are all over the place, either in terms of length, cap […]

Q: I have a Mustang Mach 1 that I’ve owned for 25 years. It has a 351 Windsor engine and a four-speed transmission. I’d like to build it up a […]

Q: I have a Chevy El Camino with a Chevy 350, a single exhaust, and power steering and brakes. I’ve had it for 10 years and it has 138,000 miles […]

Q: My Camaro has a 350 small block Chevy engine, Turbo 400 transmission, and a 12-bolt rear end. I’ve purchased many parts over the years, including Dart Sportsman II cylinder […]

I have a ’68 383 Road Runner, I bought it as a non-running car and it had a considerable cam in it when I got it—I think it is the […]