Q&A

  Q: I have a 1984 Cutlass with a Chevy 350, flat top pistons, stock cylinder heads, .448-inch lift cam (350 horsepower grind), Edelbrock Performer RPM intake with a Performer 600 […]

What’s the difference between a torque-to-yield bolt and a torque-angle bolt? I see these bolts used with newer engines. Are they the same thing? I’ve also heard that you’re not […]

Q: I’ve found that many of the best intake choices for the Ford 351C are for the engine with 4V cylinder heads. What is the biggest difference between the 2V and 4V […]

Q: I have a 350 Chevy engine that’s basically stock but is bored .030-inch over, has flat top pistons, and an Edelbrock Performer intake and 600 cfm carburetor. I just put in […]

I have an Edelbrock 2×4 setup using the 500 cfm Endurashine carburetors for my 383ci small-block Chevy that I’m putting in a ’53 Chevy hot rod pickup. In a month […]

Q: I have a 1976 Chevy Blazer with a 320 hp small block. It has a 600 cfm carburetor, MSD 6A ignition with an HEI adapter kit, and a heavy duty […]

Q: I have a small block Chevy engine. Unfortunately, I don’t know what size it is! The bore is 3.87-inch so I assume it is a 283 or a 307. There […]

I was working on my engine the other day when I pulled the distributor cap and noticed what looked like grease around the inside of the cap. But what really […]

Q: I was shopping around for a new carburetor recently, and I noticed some carburetors being described as calibrated and ready-to-run out of the box. Is there really such thing as a “ready-to-run” […]

Q: My ’72 C10 has a TH-700-R4 transmission. I want to run braided AN line to an aftermarket transmission cooler with -6 AN ports. What fittings will I need to adapt […]