It’s not quite a Chicken Little moment where the sky is falling, but the disappearance of good Gen I small block Chevy engine blocks is a major concern. If you […]
I’m rebuilding a Corvette small block Chevy engine for my cruiser boat in Australia. It’s a mid-range torque engine. I’m using Scat forged, floating pin rods, and a mild Isky […]
Will a 2002 Chevy transmission work behind a ‘99 Chevy motor? Is wiring or computer an issue? I work at a junkyard and the interchange says one year only. This […]
In today’s video, our friend Eric the Car Guy will show you how install roller lifters, roller rockers, and pushrods on a small block Chevy engine. The principals for installing […]
Q: I have a 1970s-era Chevy El Camino with a 350 engine, a TH-350 transmission, and a 10-bolt rear axle with 2.73 gears. All of the parts inside the engine, […]
Editor’s Note: Mike Mavrigian must do nothing but build engines and write stories about them. We have visions of his shop, Birchwood Automotive, set deep in the woods with Mavrigian keeping little […]
Editor’s Note: Mike Mavrigian must do nothing but build engines and write stories about them. We have visions of his shop, Birchwood Automotive, set deep in the woods with Mavrigian […]
This week in our Mailbag, the Summit Racing tech department is troubleshooting bearing-clearance measurement and engine-cranking issues in a small block Chevy. *** Q: I’m building a 350 Chevy engine and […]
I have an Edelbrock 2×4 setup using the 500 cfm Endurashine carburetors for my 383ci small-block Chevy that I’m putting in a ’53 Chevy hot rod pickup. In a month […]
Editor’s Note: The following letter is in response to an answer in a previous column concerning whether to go with a 5.3L LS engine or a larger 350ci small-block Chevy. […]